Im changing the clutch myself in my 92 VR4 and its been hell! total time on trying to get tranny out so far is 9 hours and i consider myself very mechanically inclined. When we pull the tranny off the block it comes loose about 1/4-1/2 inch and you can turn it both directions a bit and shake it up and down. but we cannot get the tranny to fall off the motor. Weve tried hooking up slave cylinder and pushed in clutch, weve wedge screwdrivers and pryed on teh tranny but it wont fall off. Any suggestions please. i checked to see if its hitting anything and its not. everythings unhooked, no bolts in it.