"shift shaft"?

Drive shaft?
Shifter mechanism?

I'm not quite sure what you are asking.....

Bob.

 

Well,this link goes to the transmission service manual:

http://www.3si.org/files/3S_AWD_trans_service_manual.pdf

You can see the "shift shaft" at page 22-13. Its the part number 12

 

You can, but it's pretty much guaranteed you will lose part #11 in the process

 

Part 11?? Is this spring the part I need to replace!!! Well,my problem is.... I dont have first or segond gears!! I Have third,4th,5th,6th and reverse,but if you try to go in first or second,you go to third or fourth!!!! My mechanic says this spring is the problem.

What do you think about?

P.D:Sorry,my english level is quite bad,I'm from Spain!

 

PM "GateCrasher".
He and Dark Helmet rebuild Getrags, he may be able to help...

Bob. -

 

You will probably lose the spring. If you have a magnet, like this:

You may be able to pull the spring back out.

I do not believe this spring is your problem. The spring helps the shifter return to the center position...between all gears. If the spring is broken or missing, the shifter will not center, but should still go into all the gears.

I believe your problem is somewhere else.

BTW, your english is very good

 

BTW, your english is very good

Thanks!!

And I have a magneto lake this.

But I'm trying to pull out the shif shaft but I can't,it moves only1"

 

it takes some force and make sure it is in nuetral

 

Im not sure if it is needed to be removed when removing or reinstalling the shift shaft (maybe both?), but I believe there is a small bolt on the tranny case, near the reverse switch, that must be removed before you are able to remove/reinstall the shift shaft.

It's been a while since I pulled mine, but I seem to remember there being 1 side bolt that must be removed for the assembly to be pulled out.

And I lost my spring a longggggggggggg time ago...

 

it takes some force and make sure it is in nuetral

Ok!! I will try this tomorrow.

 

I'm trying to pull out the shift shaft but I can't,Its very hard .If I pull hard are you sure I will not crash anything??? Pics:

 

I'm trying to pull out the shift shaft but I can't,Its very hard .If I pull hard are you sure I will not crash anything??? Pics:

did you try looking for and removing a bolt in the transmission case like I mentioned before?? (near the reverse switch)...

 

did you try looking for and removing a bolt in the transmission case like I mentioned before?? (near the reverse switch)...

I'm looking fot that bolt but I don't see anything... I'ts at the left of the reverse switcht?