Depending where it is, maybe try to drill through it or use a torch?... or try PB blaster, works great.

 

what the heck is PBBlaster and where can I get such potent liquid?

 

PB Blaster is the shit. You should be able to pick it up at any auto parts store. Too late for that now since you snapped the head and nut off. Time to get out the drill.

Jeremy

 

aww shit....so my only option is to drill the fawker?

 

So you broke the head of the screw off and the nut on the other end holding it on. So that means there is nothing but the shaft left.

Is the hole threaded that the shaft is in? If not, then just knock the shaft out with a punch and hammer. If it is threaded, then you have to drill it out or try an easy out bit + drill bit.

I don't think it is threaded. Why would you have a nut on the other end if it were threaded.

 

it's not threaded, but it has rusted so badly that I couldn't hammer it out with a punch and hammer.

 

heat it with a blowtorch then try the hammer and punch. If you can't get it out with a hammer, you are gonna have to drill it out. You could always use a dremel to cut a slot in one end of the bolt ...so you can use a BIG blade screwdriver on it, but more than likely you'l end up drilling it out then tapping new threads in the spot.

PB blaster is good stuff, as is liquid wrench. WD40 works ok, i like liquid wrench better.

Lord Warlock

 

You could always use a dremel to cut a slot in one end of the bolt ...so you can use a BIG blade screwdriver on it,

Lord Warlock

:stupid:

 

If there's no threads and you can't punch it out you're gonna have to heat it up. After that it should come right out.

Terry

 

Actually the best is Kroil, the stuff is wicked. Don't get it underneath your fingernails as it will creep up to the damn cuticle. But its more expensive, i use PB for general and for the tough stuff i bust out the kroil.

http://www.jdheritage.net/DeerelyDeparted/Items/4001.asp

http://www.kanolabs.com/