Mitsubishi 3000GT & Dodge Stealth Forum banner
1 - 5 of 5 Posts

·
homeiswheretheturbosare!
Joined
·
341 Posts
Discussion Starter · #1 ·
Well I just bought a 1995 Mitsu 3000GT VR4
It's got the stock 18's and I'm looking for a locking mechanisam for the wheals so i dont wake up one morning and find them missing any sudjestions i was thinking about THESE here but i dont know which to get 1.25 or 1.50 :-\ Thanks In advance for any help :)
 

·
resident evil
Joined
·
17,080 Posts
If its a stock 95 that came with stock 18" chromes, then it should have locks already on it.

Sam
 

·
Senior Fanatic
Joined
·
6,011 Posts
The bolt is 12 mm. To check thread pitch, measure the length of 10 threads. M12 coarse uses only 1.75-mm pitch - I don't think these are ours. M12 fine uses 1.5-mm pitch as most common - so 10 threads would measure 15 mm. If the bolt has a 1.25-mm thread pitch then 10 threads would measure 12.5 mm. Picture of the bolt on my web page below. I didn't think to measure the pitch. I use McGard locking lug nuts.

http://www.stealth316.com/2-wheelbolt.htm
 
1 - 5 of 5 Posts
Top