[TurboSinceBirth]

Benefits to bloe through vs pull? And yes i have the 20t anti surges.
Really just trying ti figure out best option

You’re supposed to have 8-12” of straight pipe in front of the maf sensor to get straight laminar flow for the most accurate airflow signal, but it doesn’t seem to be an issue. There have been instances where condensation hit the MAF sensor and caused some hiccups but that’s also pretty rare as well. Either one will work fine just depends on your budget.

 

[Brdenn18]

How much to have u make a y pipe to fit my gm maf.
Or i could prolly modify mine too.

 

[TurboSinceBirth]

How much to have u make a y pipe to fit my gm maf.
Or i could prolly modify mine too.

It would probably be just as easy for you to cut one up if you’re going to use a GM MAF.

 

[Brdenn18]

Nope. I believe the maf i have is ford.

 

[TurboSinceBirth]

Nope. I believe the maf i have is ford.

Send me some pictures of your MAF and y-pipe. If it’s aluminum and the right sensor I can weld a MAF flange on there.

 

[Brdenn18]

Send me some pictures of your MAF and y-pipe. If it’s aluminum and the right sensor I can weld a MAF flange on there.

Im pretty sure i bought my arc2 setup from u few months ago lol.
I think its the 83mm maf. And yes i can attatch a pic of my y pipe.