Mitsubishi 3000GT & Dodge Stealth Forum banner
1 - 6 of 6 Posts

·
blk93stealthes
Joined
·
9,150 Posts
Discussion Starter · #1 ·
Hi is there anything i need to do before starting my car after installing the intake...i pulled the wires that were attached to the mas..how should i reatachthem..battery on/off?

THANKS
 

·
Treblick's Nightmare
Joined
·
3,671 Posts
I would reattach them the same way you removed them. With the battery on. Of course, I don't think it would hurt to reset your ECU.
 

·
Baka! Baka! Baka! Baka!
1997 Mitsubishi 3000GT VR-4
Joined
·
1,108 Posts
It's usually recommended to disconnect the ground cable from the battery.
 

·
Matt Sherman
Joined
·
3,898 Posts
plug in the mas...turn the key. it starts..you drive....it's not that difficult:p

Matt
 

·
I am the 1.85% =
Joined
·
2,362 Posts
Yeah you are supposed to disconnect the negative terminal before disconnecting/reconnecting the MAS plug. I have done it a million times without disconnecting the battery, no harm done. But when installing an intake it might be a good idea to reset the ECU and you can accomplish this by disconnecting the battery for a few minutes.
 
1 - 6 of 6 Posts
Top