Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 4 of 4 Posts

·
Senior Member
Joined
·
510 Posts
Discussion Starter #1
Roger, Brian, et.al.

I'm installing my Greddy type S BOV, and I have a question...on the valve body, (on the silver aluminum side), there is a hose connection point angled towards the flange side of the BOV...Where is this supposed to hook up to? This is not the straight hose connection on the anodized (purple) part of the valve where the line connects, and it appears to be secondary...

Any helpful hints?

Dan J
94 Stealth TT
 

·
Registered
Joined
·
8,762 Posts
There's a hose that runs from the intake plenum to the stock BOV. Use that one. That input is where it gets the "post throttle body" pressure signal...

Man I can't type coherently today!

Trev
 

·
Registered
Joined
·
3,449 Posts
The nipple you refer to is the small angled one right?? If so, this is left open as it is used in a supercharger application, so don't use it. Connect the top straight nipple only..
 
1 - 4 of 4 Posts
Top