Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 2 of 2 Posts

·
F15 - The Fastest 1/4mile
Joined
·
913 Posts
Discussion Starter #1 (Edited)
So my old motor chewed itself up after spinning a bearing. I am having a quality machine shop rebuild for me. The block I have will need to be bored out to 100 over. Going back to stock configuration. What are your suggestions for new pistons? Another knowledgeable and trustworthy member suggested I contact Pampena for suggestions. Would like your "senior" thoughts on choices. I'm not sure how much this forum gets used so I am going to post on the main forums as well.
 

·
F15 - The Fastest 1/4mile
Joined
·
913 Posts
Discussion Starter #2
OMG, I totally misread by engine builders info, its no 100 over, its 1mm!!
So you can disregard and carry on!!
 
1 - 2 of 2 Posts
Top