MB Quart RSC216

494 Views 1 Reply 2 Participants Last post by truwarrior22, Nov 2, 2001

Matti

Discussion Starter · Nov 2, 2001 (Edited)

On these componets the crossover has three settings for the tweeter has options of 0db, -3db and -6db, which would be the best to set it at?

Also, my head unit didnt have a wire for the remote lead to the amp, i think turns on the amp when the car is on or something?? So must i run that wire to the rmt part on the amp or is it not nessacary?

Thanks

Save

1 - 2 of 2 Posts

truwarrior22

· #2 · Nov 2, 2001

0 db. If you think the highs are to high or harsh then lower them down to -3. That's like half the loudness I think.

You probably need a romote wire to turn on that amp unless your got a JBL and useing the rear speakers to tap the signal... You can wire the remote to the atenna power wire or accessory fuse.

Save

1 - 2 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month