Mitsubishi 3000GT & Dodge Stealth Forum banner

Introduction / rollercoaster ride and problem

3K views 31 replies 5 participants last post by  Mheetu 
You have wasted spark ... so every resolution the engine turns even with exhaust stroke the plugs will fire
Just for S*** and giggles take your CAS off turn it 180 Degrees from where it is siting on rear intake camshaft by removing it and turning the rectangular shaped piece sticking into the intake camshaft and reinstall it with doing this you will need to set ignition timing with a timing light just note that you have wasted spark also
But set the CAS as strait up and down as possible compared to the ground the car is sitting on not centered to the valve cover because it doesn't sit flat (putting the CAS at the 12 o'clock position) snug everything back down before turning key over again.... should pop off and run.... still going to have to dial in the ignition base timing
 
The spliced wiring by hood release ??

MFi relay cut wire with but connector ??

I Did see some irregularity in one of your caps...
Has a bulge off to the side of it
Questionable??



Your timing is dead on (timing belt)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top