Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 3 of 3 Posts
R

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I have decided to install a bleeder valve on the car to up the boost until I have the $$$ to buy a boost controller. I have an aftermarket boost gauge to monitor boost levels and need a good installation diagram and instructions on where to install the valve and which lines to tee into. Any info. or diagrams appreciated. Thanks.
 
H

·
Guest
Joined
·
0 Posts
Discussion Starter #2
Goto my site...it has pic of how it should look like.... http://www.msu.edu/user/nguyenn

Goto http://www.3000gt.com I think I saw a diagram there....someelse had it too on their site. But just cut the line like one in the pic and add bleed valvle inbetween. slowly test boost in increments til disired setting.

Phil
 
R

·
Guest
Joined
·
0 Posts
Discussion Starter #3
Thanks Hundasport. Everything went as planned!
 
1 - 3 of 3 Posts
Top