Mitsubishi 3000GT & Dodge Stealth Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Super Moderator
Joined
·
9,111 Posts
Discussion Starter #1
ONE WEEK ONLY RUN ON THIS GROUP BUY After one week, I will start collecting deposits. I can either invoice you through PayPal, or you can send the payment yourself through PayPal.

I got in contact with a well known company in the Mopar world (they are officially licensed with Mopar Performance) to have some Billet Aluminum Strut Covers (front only) made. The design replicates ECS strut covers (minus writing and the connector holders). I know they will fit 91-95 cars with ECS (there will be a notch to accommodate the ECS wiring harness) But I don't see why they wouldn't fit the 91-99 Non ECS struts, since the strut towers and mounting points are the same.

Price does NOT include shipping.

2-5 sets- $280/set ($58 deposit)
6-10 sets- $240 ($50 deposit)
11-15 sets- $220 ($45.60 deposit)
16-20 sets or more- $200 ($41.50 deposit)

I will be collecting the money for the deposits and final payment. Final payment will have to be made prior to shipping (to me).

The covers will be shipped to me first and then I will ship to you. So, the final payment will have the shipping price included.

Time Frame is about 6 weeks.

This will be the only group buy on these. I am not making any money. The price I quoted is the price the company quoted. I did, however, add in the paypal fees in the deposit and will do so on the final payment. I'm not willing to lose money either.

Also, I may offer a polishing service to these at an extra cost. I will have to see the time it takes a to polish before setting a price though.

1. dbest671
2.

THIS IS JUST AN EXAMPLE​

Von's (xwire) Car. The design of the caps will be very similar

 

·
Super Moderator
Joined
·
9,111 Posts
Discussion Starter #2
:bump: for the night crew. I will be getting these regardless of the group buy, just trying to share with the community.
 

·
-Driftus Maximus-
Joined
·
887 Posts
I actually talked to xwire about this a couple months ago. I'd love a set but fun money isn't stacked high enough right now.

Good luck and they look awesome.
 

·
Super Moderator
Joined
·
9,111 Posts
Discussion Starter #4
Yeah I talked to him too... I even asked for the person who produced them to get some made, but I never heard back. Finally, I just went off on my own and contacted a company that I have bought some Challenger parts from. They agreed to make me a set and I said I could do a group buy since I know some were looking for them.

But oh well, seems like the group buy just isn't going to happen. It's got a week none the less... but it's not looking to promising right now.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top