Mitsubishi 3000GT & Dodge Stealth Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
-=Redneck=-
Joined
·
1,480 Posts
Discussion Starter #1 (Edited)
Website for my Baby - 1991 3000gt VR4

I have been a member here since 2001 and have a lot of good times with my car and my friends on here. It has come time now though that I cannot finish my project and also need the cash that this sale will hopefully bring in.

I will post up as many details as possible about the car and I have every receipt for my current build. she was built from the inside out and is right on the edge of being complete. See the website above for lots of pics and more to come of the interior and Engine bay once they are cleaned up a bit.

$10k FIRM is what i am asking with well over $40k invested. Help a member out :)

http://nategarcia.wixsite.com/913000gtvr4sale/fullscreen-page/comp-is4c1eby/11843021-11b5-4b1e-a194-2debc85e9232/10/%3Fi%3D10%26p%3Dc1t44%26s%3Dstyle-iwxz5jne
 

·
-=Redneck=-
Joined
·
1,480 Posts
Discussion Starter #2 (Edited)
Looking for $10K FIRM for my baby. Almost to the point of parting her out. If I do it would be nice to keep her in big chunks. Engine | Trans+Transfer case | Then Chassis.

Here is the full mod list:

Engine Bay
Kevlar Timing Belt
Polished Valve Covers
SuperCar Extended Oil Pan
AEM FPR and Adapter
Maximal Solid Motor Mounts (4)
Walbro 341 255LPH pump
Stage 3 Heads
3rd Gen Crank (nitrated and Chamfered oil ports)
Pauter Rods
Weisco Pistons
3sx ARP Stud Kit
Clevite Bearings
Timing Pulley and Solid Tensioner
3sx Cam Gears
3sx oil line kit + Fuel Adapter
Copper Plugs (Stock)
PTE 720cc Injectors
MSD Wires / Coils
19THL (7* Clip) Turbos (Robbeck)
K&N FIPK
3sx Custom Crank Pulley
CX Racing FMIC
Precat Eliminators
Synapse Synchronic Blow-Off Valve

Transmission | Transfercase
Fidanza Flywheel
Spec Stage 4+ Clutch Kit (Iron FE Disc)
Transfer Case Bracket Version1

Suspension
Intrax Lowering Springs
Front/Rear Strut Bars
Adjustable Control Arms
Rebuilt Steering Rack
Upgraded Rotors+Pads
TechnaFit Braided Brake Lines
Koing Tantrums 18's w/Tires 245/40/18 (need to be replaced ASAP)

Interior
Short Shifter
Full Charcoal Int. Replacement
Clone ECU + Harness
NRG quick release Steering hub
MOMO Steering wheel (Needs to be recovered)
Full set of Nexus Gauges

Exterior
99 Sail Panels
99 Body Conversion
99 SL wing
99 Center Garnish
Skillard Front Splitter

Exhaust
Sound Performance Boost Cut-Out (welded to custom Down pipe)
Precat Eliminators
High Flow Main Cat
Stock exhaust to rear

Will post to Craigslist | Ebay | Facebook | etc.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top