Mitsubishi 3000GT & Dodge Stealth Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter · #1 ·
After work on Saturday I go to shift into first but there's no pressure when I depress the clutch pedal. I check the clutch fluid and its low so I fill it, no luck. Then I get somebody to help me bleed it but it still doesn't work. Now when I press the clutch there is a little pressure at the bottom but still doesn't shift and it won't come up all the way by itself. So I geuss I'll get it towed to that Mitsu dealer, which is right down the street, and get them to look at it, unless you guys have any ideas. I think its the clutch release(slave) cylinder, but that looks like it's a little hard to change.
 

·
Jordan
Joined
·
3,031 Posts
it could be the slave or master cylinder. My master cylinder is leaking, and i need a new clutch. Just a few of the new things i'm going to have put in this next week.
 

·
Registered
Joined
·
18,548 Posts
KuJaX said:
it could be the slave or master cylinder. My master cylinder is leaking, and i need a new clutch. Just a few of the new things i'm going to have put in this next week.
exactly....hapened to me a few times.
 

·
Registered
Joined
·
66 Posts
Discussion Starter · #4 ·
at the dealer

At around 2 o'clock I had my car towed to the Mitsu dealer. $65 to have it towed a half mile down the road. They will call later today or tomorrow, I hope its not too $$.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top