Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 5 of 5 Posts

·
Stuff and Junk and Things
Joined
·
878 Posts
Discussion Starter · #1 ·
Well, I am going to have a plenum spacer installed with a mod I am doing, that will raise the plenum only .25 inches. I'd imagine people have also put a strut bar under the 575 hood? and if you keep piping level or below stock IC piping you wouldn't have any fitment issues right?
 

·
EGR BLOCK TIME!
Joined
·
1,354 Posts
if its just a 1/4 i think it would be alright.
here is a pic of my pipeing kit i put in.... i put the t-bolt clamp threads facein up, for easy access.


the best way is just get some clay or something and make it into a ball and set it ontop of your plenum, presto clay plasty gauge :p
then slam the hood and open TaaDa
 

·
220K club
Joined
·
975 Posts
I had the plenum spacer and she fit fine with the 3SX strut tower bar, and DN Perf IC pipes as well.
Getting the T clamps for the IC couplings aligned so it does not hit the hood was an issue.
 
1 - 5 of 5 Posts
Top