Mitsubishi 3000GT & Dodge Stealth Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
119 Posts
Discussion Starter · #1 ·
After reading several spark plug threads I decdided to swap out my old plugs for some coppers. Things were going fine and I was finishing putting things back together. I tightened down the right bolt on the throttle body. As I tightened the next bolt down it started to get a little hard to turn and then all of a sudden very easy. This was because the bolt snapped with part of it still in the plenum thread. What can I do? Can I drill out the piece of the bolt and then try to rethread the plenum? Any help would be greatly appreciated.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top