Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I’ve got a 95 vr4 with the 6 speed. I just did a full build and trans rebuild and put the trans and engine back together. Upon doing so, I found that one of the bell housing bolt holes has been stripped out and the bolt will not catch the threads. Has anyone drilled and retapped one of these holes? If so, what size drill and tap? I hate to leave a bolt out of it.
 
Joined
·
17,431 Posts
The tcase holes are 1.75. The side ones that go in from the motor side are fine thread.

Sent from my SM-G955U using Tapatalk
 

·
Registered
Joined
·
9 Posts
Discussion Starter #5
Awesome. Thank you. I’ll pick up the m-12 x 1.50 for the bell housing to engine holes
 

·
Registered
Joined
·
9 Posts
Discussion Starter #7
Lol damn I’m glad you said that. Good catch. I was just about to pick up the wrong one haha
 
1 - 7 of 7 Posts
Top