Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
Good morning, I installed the auto trans shifter bushings yesterday, although it wasn't a 20 min process. Maybe I have to big of hands, but what a pain to get the bushings (OEM) to stay installed in the shaft when sliding the center sleeve back in place. Is there another process that is better to ensure no damage to the plastic shaft / sleeve bushings?

I am sure I damaged on and will have to redo this within the next year, as I don't have small enough hands to get into the area to hold the gear selector up, and install bushings and then slide center sleeve in without damaging the plastic bushing.

Any tips for next time would be great.

Thanks,

OC
 
1 - 2 of 2 Posts
Top