Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 4 of 4 Posts

·
Senior Member
Joined
·
4,613 Posts
Discussion Starter #1
I am going to start on the rebuild... having very little knowledge of the internals of this car any tips or tricks I should pay attention too.... I suppose there isnt a step by step :D I already have the rear oil seal, clutch and flywheel and dust shields off, as well as all the belts and timing covers... and it is on the stand off course :D heads will be off sometime today or tommorow.. then what?
 

·
Registered
Joined
·
1,681 Posts
man I'm sure glad youre asking all this questions now...it sure is going to help me out when I get started on mine.....thanks:cool:
 

·
Wild & Wacky Meerkat
Joined
·
1,599 Posts
Tip:

Don't break anything.


:D

heh


Good luck Brain. I hope it works out well, I'm going through that pain next summer most likely (if I have the cash)

Elton
 

·
Senior Member
Joined
·
4,613 Posts
Discussion Starter #4
The block is completely apart now bare block.. it took all of about 3 hours and 800000000 plastic ziplock bags... but it is nice having it done now.. hopefully I can get the heads out tommorow or tuesday and start this whole thing in motion
 
1 - 4 of 4 Posts
Top