Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 5 of 5 Posts

·
Registered
1gen VR4 GTO. 4bolt block with forged crank. 15G hong kong hairdryers and supporting mods.
Joined
·
71 Posts
Discussion Starter #1
Hello,

Do anyone know if my AEM 30-1311 s**tbox haves internal pull-up resistor for IAT pin 52? Installation instructions won't tell if there is one, and what is the resistance if there is one.

The installation instructions:
https://www.jegs.com/installationinstructions/0/017/017-30-1311.pdf

Say just that it is dedicated input. No information if there is pull-up resistor or not.

286691

So is it something like this?
 

·
SDSU Alumnus
Joined
·
3,222 Posts
I know that 30-6311 (Series 2) has the typically dedicated 2.2k ohm, but that is about it ?‍♂ lol. FWIW, S2000's Series 1 have the same resistor rating, per their forums.

-sent from my Galaxy Note 9
 

·
Registered
1gen VR4 GTO. 4bolt block with forged crank. 15G hong kong hairdryers and supporting mods.
Joined
·
71 Posts
Discussion Starter #3
I know that 30-6311 (Series 2) has the typically dedicated 2.2k ohm, but that is about it ?‍♂ lol. FWIW, S2000's Series 1 have the same resistor rating, per their forums.

-sent from my Galaxy Note 9
Thanks. Best information this far until proven to be otherwise.

I'll calculate the graph values with this and see how it works.

Have a nice day.
 

·
Registered
1gen VR4 GTO. 4bolt block with forged crank. 15G hong kong hairdryers and supporting mods.
Joined
·
71 Posts
Discussion Starter #4
Your information seemed correct. IAT shows now reasonable values
 
1 - 5 of 5 Posts
Top