Mitsubishi 3000GT & Dodge Stealth Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
So I have a 1991 3kGT vr4 with a very bad rod knock, Bearing spun. I was planning on Just buying a new engine since the old had alot of miles. Found a couple of engines but I'd like to see what some of you recommend since I dont know much about buying engines online.
 

·
Registered
Joined
·
137 Posts
If the block is usable, why not just rebuild off the stock block? You'll probably land around the same price point after machining costs, but you'll have a completely brand new engine, not some unknown used one.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
If the block is usable, why not just rebuild off the stock block? You'll probably land around the same price point after machining costs, but you'll have a completely brand new engine, not some unknown used one.
I was thinking of going something close to that route but since one of the heads has a Extremely bad cam lobe and roller, plus I don't really have much of a garage. So engine rebuild would suffice?
 
1 - 3 of 3 Posts
Top