Mitsubishi 3000GT & Dodge Stealth Forum banner

Aem series 2 settings help on antilag and two step.

3K views 7 replies 4 participants last post by  benson8277 
#1 ·
Hey guys was wondering what your settings were what cut you used and such mine are as follows and i can only get like 3-4lbs of boost any help would greatly be appreciated.

2 step medium cut
alt spark trim -40 degrees
alt fuel trim 0%
alt off above 8500 rpm
alt on above 4000 rpm
alt on above -2 psi
alt off below 60.2 TPS
alt on above 65% TPS
Alt overboost 15psi


two step settings are:
fuel cut 7500
ignition cut 5000
 
#2 ·
Bump need help?
 
#3 ·
figured it out sounds nasty!!!! wooooo ill video it :) created 15lbs but turned it down to 7 lbs so i dont break shit
 
#7 ·
Bahahahah yah screw em if they dont like the sound of power. i changed the two step ignition cut. And my alt spark trim.

just to let u know you dont wanna run -40 tooo much go to -30 and tinker with the ignition cut till u find your boost raising or lowering every setup is different i just tinkered with the settings and thats what i came up with.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top