Torque value of axle nut?

[Dj4play]

Originally Posted by iceman_ii

What I am saying is that after you torque it, it will NOT be set to put the cotter pin in, you are most likely going to have to change it anyway, so what is the use. There are torque specs to sweat the load over, but this isn't one of them.

I love this man ^

[iceman_ii]

Originally Posted by Dj4play

I love this man ^

I can't tell if thats a nod to my pragmatism, or a subtle jab...

If its a nod, thank you sir, if a jab, piss off ya wanker.

There, all bases are covered

[Dj4play]

Originally Posted by iceman_ii

I can't tell if thats a nod to my pragmatism, or a subtle jab...

If its a nod, thank you sir, if a jab, piss off ya wanker.

There, all bases are covered

its a nod.

[iceman_ii]

Originally Posted by Dj4play

its a nod.

I figured as much, but I had to keep up the humorous theme... sorry about the whole "piss off" thing

[veerfour05]

I always torque it and then if it isn't lined up I tighten it until it is.

[Blue94VR4]

166 ft according to the manual, but no more than 186