Need pictures of gearset sitting in 6 spd end case

[SHiVeR-91VR4]

Looking for any pictures anyone has of the gearset sitting in the 6 speed end case.

Building some solidworks end case models and I see some room for improvement over the stock design, but I want to confirm that there is enough room to beef it up in those areas on the inside.

I need stuff like this:
buildup 011.jpg

but looking down all around the case so I can see how close to the edges of the case the gears get. If someone could even throw one shaft in there at a time and take pictures all around (so there is less interferance) that would be even better. It would also be nice to have the output shaft assembly in there as well to see the clearances there.

Thanks,

Chris

[SHiVeR-91VR4]

bump, no one has theirs pulled?

[DCIV]

you have the pics of the one I sent you when I was pulling.


Coop

[SHiVeR-91VR4]

Got everything I needed, thanks guys!