Mitsubishi 3000GT & Dodge Stealth Forum banner

plz give thoughts mbc/ebc/emc ect!

920 views 0 replies 1 participant last post by  spaceace60 
#1 ·
ok heres basic setup 92vr4 vac reduction,mbc,apexiII,timer,boomslang harness,cold air intake,99 lifters,hot wired warbro,krank vents,empty pre cats,test pipe,fpr/guage,msd coil/msd wires,after mkt y pipe,things i have but not yet installed aem wideband a/f guage,aem boost gauge,450cc inj! i realize some of these items are not needed to mention but my goal is to get to about 400hp(SAFELY and minimal tuning!) i want 14-15psi to be my max!(again longevity)not sure if what i have will end up being a pita? or should i go to something like an aem emc since it has built in ebc,a/f,o2 readings and everything that my apexi will do and more?? or am i asking for more tunning headaches? as after new motor was put in it purred like a kitten at idle and bucked like hell under load on several runs!(even though 1 pass i made didn't)i was only getting little over 7lbs boost on retard(stock guage) i havent got an accurate intercooler pressure test yet!!! bought aem fpr/guage as thought maybe stock fpr was being pushed to hard? any set suggestions appriciated!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top