|
|
|
11-27-2007, 05:11 PM
|
#22 (permalink) |
|
Forum Member
|
Re: Part number for VSS removal tool (valve spring compressor)???
[quote=thetjkid;4625690]that kit looks awesome... does it work well?
[quote] Yes, it works great. A 3/4" pipe extension gives you more leverage. I bought some longer bolts and 1/2" washers to get the main brackets above the cam bearing cap alignment sleeves. Be sure to have a extendible pen magnet to grab the keepers. The magnet makes it easy to install the keepers too. You must have the cams out to use this tool. Good luck.... |
|
|
|
11-27-2007, 05:57 PM
|
#23 (permalink) |
|
Oh SNAP!!!
|
Re: Part number for VSS removal tool (valve spring compressor)???
i am also interested in this tool..more info please...
__________________
If you feel I have answered your question..leave me some rep...thanks
**1ST place RMG 07 best engine** Like the snake the BITE must be felt and not seen, goin super, until then super slow want some!!! 1st car with the Enkei RZ-5 18''x8.5'' *534x306*  1994 Dodge Stealth R/T TT~Pearl Yellow |
|
|
|
|
11-27-2007, 08:15 PM
|
#24 (permalink) |
|
Forum Member
|
Re: Part number for VSS removal tool (valve spring compressor)???
The quality is good and I have used it on 4g63s and 6g72s. I guess you can use it on almost any OHV or OHC engine. It works much better than the Snap-On you push down with your hand. The leverage makes the job easy.
|
|
|
|
 |
|
| Thread Tools | |
|
|
