- Stock boost, 95 VR4 - knock problem
- palm m100 desktop
- Maft Pro Mounting Locations?
- got ripped off? tt vs na ecu
- New to tunning, need help with tt 10:1
- what should 02's be when tuning?
- Greddy emanage question
- Emanage Blue - Timing with TPS sensor = ghey
- Stalling problems?
- Emanage Blue
- Hybrid Datalogger
- New to dataloggers
- Tuning with an Intel-based Macintosh
- Help!!! what is the value of C3
- boost duty cycle vs boost target
- GM boost solenoid settings in AEM?
- tranny probs
- AEM noob with a ? about timing
- base tune for afc with 550s
- HKS VPC/ Injector questions help
- OBD1/OBD2 scaners/tunning
- venom 400 module in N/A?
- Datalogging issue
- ECU Trouble Possible?
- wow holy crap please help!
- Tuning advice
- "ACLE" = acle enrichment - what controls it...
- Data Logging problem... Speedo/odometer not working
- MAP ECU 2 or Ultimate On OBD 2 Vehicles ??
- tuning emanage, also is my f*ing O2 shot
- Question on Temperature range
- How To Advance the timing
- revived: No spark at 3-6
- anyone running GM 3 bar 16040749
- AFC vs. Emanage Blue??
- building boost off line w/ aem
- AEM and Air Conditioning control in 2G
- Capacitors
- Why does my boost climb, drop then climb, AEM Log inside..
- Noobie guide to tuning.
- Emanage Ultimate Install thread
- vr4 eating ECUs
- Need help with 9638 ECU
- O2 Trim: load vs. no load
- Where can I find a replacement?
- Intake Air Temp 91/Stealth TT "code 13"
- opinions for mafT-pro...
- Tuning on SAFCII
- phantom knock or not ?
- Fuel Cut problem on a N/A
- Need ECU repair help
- how to run a hotpin to my palm?
- emanage blue in n/a
- Any good 3s AEM EMS tuners (dynos) around Nebraska?
- PEG S300.. hotsync cable not working...
- safc 2 tunning/ help
- e-manage blue install woes
- Looking for map for emanage ultimate
- datalogging software??
- Idle air controller help
- Ecm problem Not powering injector please help
- do you use emanage?
- datalogging cable schematic?
- MAF capacitor: there's only one, and it can blow up too
- Ecu Problem
- help with tunning
- What Fuel setup to go with?
- Bad FPR?
- Greddy Emanage VS Apexi SAFC
- 3sx o2 sim.
- Data Logging for 94 stealth/3000GT
- Quick Question about Scanmaster 3
- Scanmaster 3 vs. Innovative wide band
- What are some AFR's
- Top end cut out in 4th Gear - Logs included -
- Tuning SOHC
- 16PSI, 50shop and pump gas - possible?
- AEM installed, no more tach
- Dataloger not loging Help a Noob
- Scanmaster with TurboBob ECU - Software update needed
- Idle A/F problem
- G-Force ECU
- No O2 readings with MMcD stock ecu 91 TT
- Palm N stein logging
- NO spark no fuel please help
- AEM WB wirign question
- How does a BAD Wideband Sensor Present
- NA ECU tuning
- Knock Knock Knock
- Dual or Single Channel Wideband?
- Anyone in MD with tuning experience
- No spark at 3-6
- ecu dataloggers -hybrid
- MMCD Data Log
- PC dataloging
- Datalogging Using a Palm
- input on maf-t
- Need help with tuning Knock troubles!
- Need some advice...
- ECU resetting?
- RPM signals going to ECU
- O2's at Idle
- Wanting to put my AEM ems in on my own???
- AEM or Emanage Ultimate?
- Some PIN questioning.
- EGT to AEM?
- Any new tuners who need a wide band?
- Yes, its another car wont start!!!
- MafT installed, now have a CEL
- MAP-ECU2 is out!
- Trouble with ECU
- Safe AFRs for Lean Cruise?
- Map Sensor
- Rev limiting via PTU live?.
- Emanage Install Trouble
- Differences between california and federal (1991 vr4 turbo)
- Quick ecu/emu questions for L3377ttt noooooob
- WB numbers vs SAFC setting
- Need Some Help Please
- Ecu Problem....I believe and what i was told???
- ECU Replacement caps..3 or 4?
- Looking for tach signal
- GTO ECU MD159964 Good? Bad?
- I'm new to upgrades..
- map sensor off in VAC?
- -= Ultimate Emanage Tuning Thread =-
- ARCII to AEM ECU
- safc question
- AEM EMS and keyless entry remotes.
- Need TMO Datalogger Software Please
- USB logging?
- EMU - Airflow adjust map
- ECU rebuild service?
- Can I just alter stock ECU map/sensor or is piggyback fuel computer the way forward?
- GM MAFT Information/Install
- Never synchronized?
- ECU's???
- Can anyone tell me which logging software to use for this?
- Recommended Tuners in the Seattle Area
- Tuning but no tps
- negative 41 degrees?
- OBD2 datalogging software
- emanage stock setting
- 21 psi! EMU tuning
- Timing induced knock
- Greddy Support tool
- Arc2 vs MAF-T Blowthrough
- First log found lots of knock....
- In need of aftermarket FPR?
- The eManage Downloads Thread (All Models)
- EMS repaired now dead tach????
- What does this SRS code mean?
- Megasquirt Tuning
- AEM wastegate duty cycle settings
- aem tuner in nashville,huntsville, birmingham?
- data logging cables
- HKS-F-CON Opinions
- 9b`s, 14psi, having to pull timing?.
- AEM EMS with 94 active exhaust
- AEM ecs vs. ARC-2.....
- AEM EMS ... Connection failure?
- Which Data Logger Do I Need
- Tuning with a wideband ?
- ecu compatability
- Stock 02 Sensor Removal
- 1st generation wiring harness to 9306.1 – 9505.3 MD192589 ECU
- First Time Logging.
- Emanage compatibility problems
- Map-ecu
- What are your ARC2 settings?
- Perl translator for MirageCorp Hybrid Dataloggers
- emanage pros and cons
- AEM cal for 720cc injectors
- Hows my tune??
- first time logger...
- ECU problem? Low idle, plugs failing.
- is an AEM "baro error" significant
- Coil on plug/waste spark knock controller
- crank pickup vs cam pickup AEM
- IAT Sensor Placement
- Data Logging Software for Computer
- Apexi AVC-R self learning duty cycles
- aem dwell settings
- aem start up tune need help
- AEM V1.11 to V1.19 Conversion Questions
- Stock wideband plot available?
- Logger Not Connecting
- E-manage parameter pics.
- Datalogging
- First log....any input?
- AEM car won't start after battery disconnect
- need base tune for tt with n/a ecu.....
- Need ECM!!!
- aem uego dual sensor
- problems with AEM!please help
- data logging!!!!
- Safe tune with good gas mileage for 550's
- Apexi Neo installed
- OBDII & Emanage tuning.
- timing question..
- best tuning system
- 1996+ OBD II ECU flashable?
- choosing the RIGHT electronics
- how to get MMCD to my PALM?
- pmas users... help me out
- Anyone know the color of the Temp Signal Return wire off the stock maf hanress?
- Do u guys use afc for streen tune or dyno?
- AEM UGEO/datalogging/help!!!
- Mega Squirt on a 3S?
- computer problem
- computer problem
- aem uego dual sensor
- Puttering
- AEM EMS vs MMCD ?
- Using the SAFC2 on a 3si
- SAFC vs E-manage
- SAFC2 quesiton!!!
- IAT sensors?
- Datalogging with Emanage Ultimate
- ecu compatability
- fueal tuning ?'s
- emanage install help...
- CAli vs fed spec
- AEM control purge control system
- ? on O2's with safc2
- Installing MAFT. Need Tach signal
- AEM break points
- what do i need to contol timing in emanage??
- AEM UEGO trouble's
- Tuning Problems
- Quick question about ETACS
- ecu pinouts
- AEM start-up vs colder weather
- mmcd and pausing?
- starting with aem ems
- Datalogging help/which unit or advice-thanks.
- Just put in 560s, o2s wont cycle, safc
- EMU Jumper setting help...
- Apexi AFC knock detection
- E-Manage Map
- 720cc EMU tuning help...
- EMU clean spark plugs?
- What am i missing using na harnes
- S-afc install
- TT ECU. Check Engine Light
- Wiring harness Question
- AFR Reading
- Why am I knocking?
- Narrowband tuning
- No Ecu Power, Help!!!
ECU Tuning | |
|
|
|