Alright now on the final step of the removal process!
Step #8 FRONT BUMPER COVER REMOVAL. First and foremost remove the turn signals. Unscrew the screw holding it in the front. It will now slide forward. Disconnect it and place aside.
Now to the center of the bumper. We will first deal with the section right on top and in front of the radiator. First, remove the rubber strip. Next remove the bolts along the inside of the bumper cover as shown below:
Next, we will deal with the sides. First remove the front dirt skirts from both sides and set aside. You will also notice the dirt guards on the bottom of the bumper, removing these as well. Now there will be a bolt holding the bumper to the fender, an extension helps here to remove this bolt.
Next set the headlights to the "up" position. Remove the bolt holding the headlight lens in place and remove it if not already removed.
Next remove the three bolts holding the lens bracket in place. At this point the bracket should be able to slide out with a little finagling.
Next, on the inside of the fender going vertical are several bolts holding the bumper in place, remove them. *See illustration below*
Finally, underneath the bumper are a row of screw-clips holding the bumper to the radiator vent. Remove these and set aside. At this point the bumper will slide off horizontally with a little coaxing.
*CONGRATULATIONS YOU ARE DONE WITH THE REMOVAL STAGE!*
