Dragging SPEC II, not sure why
Hi,
I recently installed new SPEC 2 clutch and now I have a hard time getting into the 1st gear. Problem only exists with engine running and it looks like clutch not fully disengaging problem. Car wants to move forward a bit when I am trying to shift into the first. Here is what I did so far.
Bled the system, replaced master/slave and rubber line, adjusted the pedal. Problem still there.
I thing I did not do (it was very stupid of me) was to replace or resurface flywheel during the clutch swap. My friend said that it looked ok and it had only 20K on it so I though I would be ok. Can a bad (eneven) flywheel cause clutch disengagement issues?
Any other suggestions?
Thanks
__________________
94 3000GT VR4 (upgraded) 
"Your 1994 Mitsubishi 3000GT VR-4 is one of 1650. There are 57 other cars that were made with both the same interior and exterior color. Exactly Identical - 8"
For sale:
1. used A/C belt (10K on the belt)
2. Stock front and rear sway bars.
3. 3SX dual O2 simulator
4. Used 2'' couplers/reducers/hump hoses
5. Used stock flywheel |