3000GT/Stealth International Message Center - View Single Post - Boost Problem after EBC install...help plz

bcarroll76 · 06-11-2008, 05:40 AM

that is what I have, mabye it is a setting with the boost controller? I have the vaccum line that used to be on the y-pipe going to the new solenoid...(this is the one ehat runs down to the rear wastegate and has the stock h fitting, and blocked off the line that goes to the stock boost solenoid..

I have another vaccum running from the y-pipe to the boost side of the new solenoid...

Can someone give me help on setting up this EBC.... it has start boost setting, which I set to 7.5, it has low and high boost setting which I have at 7.5 and 15, it has High and low gain which I have set at 80%... and warn at 16 ..

Does anyone use this BCU + EBC that can help?

06-11-2008, 05:40 AM	#3 (permalink)
bcarroll76 I love my money pit!! Join Date: Apr 2008 Location: where fines are less Drives: 95 Pearl VR4 Trader Rating: (2)	Re: Boost Problem after EBC install...help plz that is what I have, mabye it is a setting with the boost controller? I have the vaccum line that used to be on the y-pipe going to the new solenoid...(this is the one ehat runs down to the rear wastegate and has the stock h fitting, and blocked off the line that goes to the stock boost solenoid.. I have another vaccum running from the y-pipe to the boost side of the new solenoid... Can someone give me help on setting up this EBC.... it has start boost setting, which I set to 7.5, it has low and high boost setting which I have at 7.5 and 15, it has High and low gain which I have set at 80%... and warn at 16 .. Does anyone use this BCU + EBC that can help?