3000GT/Stealth International Message Center - View Single Post - Boost Problem after EBC install...help plz

binary89 · 06-11-2008, 01:29 AM

Make sure your settings on your EBC are correct be sure you are dialing in a set and gain and not a desired PSI. Start with a set 30 and work your way up use a gain 6-10. 6-7 PSI is indicative of a closed connection where boost is reaching your waste gates but is unmetered.

Your connection should go like this. One line goes from your y-pipe to your new BS, then a line goes that from your BS to the H fitting with goes to both turbo wastergate.

Directions take the line that comes from the H fitting and goes to the Y-pipe, connect it to the output of your BS, cap off both lines that go to your stock BS. connect a line from your Y-pipe to your input on your new BS, Cap both lines that go to your stock BS.

06-11-2008, 01:29 AM	#2 (permalink)
binary89 Forum Member Join Date: Nov 2006 Location: Overland Park, KS Drives: 93 FD, 95 Vr-4 Trader Rating: (0)	Re: Boost Problem after EBC install...help plz Make sure your settings on your EBC are correct be sure you are dialing in a set and gain and not a desired PSI. Start with a set 30 and work your way up use a gain 6-10. 6-7 PSI is indicative of a closed connection where boost is reaching your waste gates but is unmetered. Your connection should go like this. One line goes from your y-pipe to your new BS, then a line goes that from your BS to the H fitting with goes to both turbo wastergate. Directions take the line that comes from the H fitting and goes to the Y-pipe, connect it to the output of your BS, cap off both lines that go to your stock BS. connect a line from your Y-pipe to your input on your new BS, Cap both lines that go to your stock BS. __________________ Rides 1995 White VR-4 : Blitz SBC ID III, Greddy Type RS, Stillen Intake, 3SX Downpipe, 3SX Pre-Cat Eliminators, 3SX 8000k HID Kit, MirageCorp Hybrid Datalogger 1993 Blue Rx-7 : StreetPort + 3mm Apex Seals, PFS Tunned Purple ECU, Walbro 225lph Fuel Pump, Greddy Rubix injector controller, 3" Turboback exhaust, Exedy Twin Plate Clutch, Fiske FM5's with Eagle F1's Last edited by binary89 : 06-11-2008 at 02:25 AM.