[bcarroll76]

Hey guys I have a problem after installing my EBC. I am using the PIT + EBC and I have it all installed and the problem I am running into is when I start building boost it only gets to like 6.1 at the most and it seems like it is hesitating while building boost like its jumping up and down..

Here is how I ran it:

I ran the vaccum hose from the unit and T'd it off in the FPR line.

I disconnected both lines on the stock boost solenoid and capped them off.

Does the stock hose that runs to the Ypipe actually run to each wastegate? Thats the way it looked to me so I used that hose and connected it to my new boost solenoid (please correct me if I am wrong) it looked like it had one vaccum to the stock boost solenoid and 2 others that ran to both wastegates...?????

so then I ran a new vaccum line off the ypipe to my "boost only" pressure source on the new boost solenoid....


Mabye I am all screwed up here... help me out please this really sucks


I have not done the vaccum reduction but will in the future and I know the BCU+ is not a common ebc so lets keep those comments at a minimum please and just stick to the setup...

Thank you so much