3000GT/Stealth International Message Center - View Single Post - EBC install ALMOST THERE SO CLOSE quick help

binary89 · 06-10-2008, 03:33 PM

What boost controller do you have?
The picture you have shows a EBC configured to read boost, the boost gauge is just a add on. This hose usually is a Teflon hard hose. As far as your solenoid connection you can use a 4mm or 6mm, connect a 4mm hose to a 6mmm etc... Just make sure the connection is tight.

Yes ignore the Boost Gauge

06-10-2008, 03:33 PM	#3 (permalink)
binary89 Forum Member Join Date: Nov 2006 Location: Overland Park, KS Drives: 93 FD, 95 Vr-4 Trader Rating: (0)	Re: EBC install ALMOST THERE SO CLOSE quick help What boost controller do you have? The picture you have shows a EBC configured to read boost, the boost gauge is just a add on. This hose usually is a Teflon hard hose. As far as your solenoid connection you can use a 4mm or 6mm, connect a 4mm hose to a 6mmm etc... Just make sure the connection is tight. Yes ignore the Boost Gauge __________________ Rides 1995 White VR-4 : Blitz SBC ID III, Greddy Type RS, Stillen Intake, 3SX Downpipe, 3SX Pre-Cat Eliminators, 3SX 8000k HID Kit, MirageCorp Hybrid Datalogger 1993 Blue Rx-7 : StreetPort + 3mm Apex Seals, PFS Tunned Purple ECU, Walbro 225lph Fuel Pump, Greddy Rubix injector controller, 3" Turboback exhaust, Exedy Twin Plate Clutch, Fiske FM5's with Eagle F1's Last edited by binary89 : 06-10-2008 at 04:01 PM.