[Theo_VR4]

Has anybody else had a whirring noise bell housing side after having the plate welded in? Ever since I had mine done I've had a whirring noise idle and driving. I replaced the input shaft bearing and still had it. Bret said sometimes the hole is mishapen from the welding so I ground it down and put the bearing back in, the input shaft fit much better but still makes the noise. Is it most likely still that input shaft bearing? I didn't think it would be any other bell housing side bearings because they shouldn't be moving enough at idle to make so much noise.

It's bell housing side, and not the throw out bearing. I have the tranny out again and just wanted to see if anybody else had experience with this type of noise before I just replace the input shaft bearing again. Since the hole was a little ovaled I guess the bearing could have been damaged and make noise even though the hole is now fixed... or maybe the hole needs a smidge more reshaping.