Re: -= Ultimate Emanage Tuning Thread =-
Hey guys is it possible to control things like meth inj or nitrous from the emanage, i was just looking at the unused pins with stage 3 wiring, and there are 4 pins on connector B, so i looked it up on the install manual and they are listed as NVCS / Relay Channel control lines. "These channels can be used for relays to activate desired devices."
but when i looked them up iin my user manual, there is nothing there but these two notes:
Make sure the wire that was cut is taped up to prevent any short.
When using this feature the proper channels must be configured in the “I/J” set up in the
Parameter setting in the software and make the necessary jumper setting to activate these
channels.
1) now if i understand this correctly we can use the injector signal a and b to control two relays, so my question is would it be possible to create a two stage meth inj system which is ONLY controlled by the emanage?
2) and if it is possible how detailed can we make those maps? im wondering if we can control them based on boost levels and rpm.
3) im also assuming that since we would be using relays to control the meth inj the best we could do is to select between two flow rate nozzles, but they would either be fully on or fully off, the relay wouldn't be fast enough to use pwm correct?
|