3000GT/Stealth International Message Center - View Single Post

Climber · 05-09-2008, 02:45 PM

No, don't just pull it. It has hooks.
I think used I used some bend coat hanger to go into the slot and hook the wire behind the hooks and pull them in, while lifting that side.
I remember it being a bitch.
That knobby should just come off by pulling btw.
What I did was cut away all the leather around it (wasn't planning on reusing that), without cutting into the foam. That gives you more view.

On the other hand you can check out triplex mitsus website and go to collision parts and they might have it for a few bucks. Then you can just break it.

what's handy is those little lights on a bendable stick. Like 1/8" thick.

05-09-2008, 02:45 PM	#4 (permalink)
Climber Dutch by nature! Join Date: Oct 2000 Location: Corona, CA Drives: 3000GT VR4 Trader Rating: (1)	Re: Leather install Problem. No, don't just pull it. It has hooks. I think used I used some bend coat hanger to go into the slot and hook the wire behind the hooks and pull them in, while lifting that side. I remember it being a bitch. That knobby should just come off by pulling btw. What I did was cut away all the leather around it (wasn't planning on reusing that), without cutting into the foam. That gives you more view. On the other hand you can check out triplex mitsus website and go to collision parts and they might have it for a few bucks. Then you can just break it. what's handy is those little lights on a bendable stick. Like 1/8" thick. __________________ Life's too short to go slow.