05-08-2008, 06:56 PM
|
#1 (permalink)
|
|
At least it runs....
Join Date: Jul 2007
Location: northern nj
Drives: 93 VR-4
|
NEED HELP ASAP building heads....
ok so ive come to a coupple rodeblocks...
my heads are off the car right now.
i am at the point where i need to put the cams in and i dont understand some things with the seals.
1) do the cams just spin in the cam caps?... assuming if yes i sould put some assembly lube in them...
2) also do i need to put some RTV on the cam caps? i believe the shop manual says something about putting it there but it is not clear
3) the seals that go by the t-belt sprokets.... do i just put some assembly lube in the lip of those and slide them on?
is the cam sposed to spin in those seals... seems like it.
4) dose it matter where each of the rocker arms goes... they have different numbers on them
5) when i put the cams in i should possision them so that the timing mark on the sproket is in line with the timing mark on the valve cover correct?
any and all help is appreciated... i would really like to finish this tonight so please respond asap...
thanks so much,
-adam
__________________
 Performance: New shortblock (ross pistons 40 over, forged crank, shotpeened rods, ARP rod bolts) , Stage 3 Ported and polished heads (w/ 3rd gen lifters, dual hi-rev springs, and titanium retainers, ARP head studs), TEC 15Gs, Ebay Manifolds, 3sx crank pulley, Denso Iridium plugs, MSD 8.5mm wires, Optima red top, Dejon intake tubes, K&N FPIK, Greedy Type-S, ATR Turboback exhaust, Gutted precats, test pipe, SPEC Stage 3+ clutch, RPS flywheel, Dual Core FMIC, DN y-pipe, Maximal Solids, Free Boost Mod, FFdynamics rad and fans, EGR Blockoffs, short throw shifter.
Sitting in garage to be installed: EvoVIII 560cc injectors, Walbro 255lph fuel pump w/ hotwire kit, Apexi SAFC II black edition |
|
|