[jba3]

I am planning on running an evo3 16g setup, with a stock bottom end at the stock 3.0L and either 8.0:1 or 8.5:1 forged pistons and rods. I am hoping to make 600whp on pump and/or pump and injection.

Can you recommend a setup (including nozzle size) to use for this configuration? Would it be the same as the other setup that was recommended to 3KGT2NV?

I have alky injection for my evo but haven't installed it yet, so I am a little familiar with the concept but I definitely don't know enough to piece together a system.

Thanks!