I don't have the car tonight or I would go take some pictures . This is the only one I have. This was right after I put it in, before rubbing it down with mcguiars. Then it gives a little more of that leather sheen and smooths it out. Front is very tight and looks good. My full critic would be that the do fit very tight. Actually so tight that I lost a little bit of the the front seat side bolsters. Their not quit as tall as before. As mentioned the back seat seat belt wholes. The back of my seats had 2 zippers on each side. Seems most have a board that screws on the back. I had to cut the zipper part out and sewed it on. Also the clip parts on the bottoms of the front seats. Not sure that was necessary. (well my daughter did the sewing). Over all I was very pleased with the quality and final results. Also it is full leather, bottom sides everything. no vinyl like the original.
PM sent with some important information
__________________
FIPK, Megan Racing DP, Gutted Pre Cats, MBC, Walbro Fuel pump, Ground Controls, Unortodox Racing Flywheel, Slotted and Vented Rotors. Maximal Rear adjustable upper control arms. Poly Mounts
Under the Knife for: Rebuilt engine with Crowler Rods, and Wiseco pistons. 13T's, 550CC injectors, SAFCII. Rebuilding 5 speed 25spline tranny.