[VR-4-ever]

Hello everyone.

All questions and comments applies to: 1995 3000GT VR4

My car is equipped with a factory 2-button keyless entry receiver and remote. (No trunk release)

(Remote)
FCC ID : E4EG8DA
DOC/MDC : 1814 K1010
OMRON G8D-281M-A

Everything works fine, but a few years ago the loop hole on the hub/casing where the key ring hooks to broke off. I have to carry the remote separately from the keys if I want to use the keyless entry. Months later I decided to stop carrying my remote just incase I lose it.

FAST FORWARD TO NOW......

Finally I had decided to buy a new remote. I found one on ebay, but someone beat me to it. Then I found another one on ebay. But this time it has three buttons (unlock, lock, and trunk) instead of two (no trunk) and the numbers in the back were off by one.

2-button
OMRON G8D-281M-A

3-button
OMRON G8D-282M-A

Thanks to 3si.org and the good people here, I found out that this remote should work on my receiver. AND IT DID!!!

Now, I am curious if I can install a trunk release into my car and will the receiver support it. There was a wire harness that went into the receiver, but didn't have anything connecting to the other end, which was pointing to the rear of the car. Could that be the attachment for the trunk release?

If anyone can help me on this, I thank you in advance.