Quote:
Originally Posted by Telefonica
Question:
When I connect to the EMS in my car and I go to the fuel table, on the left there's a "Load Breakpoints (PSI)". When the car is off but key in the ignition and I'm connected to my EMS, this acts more of a TPS (throttle position sensor). When I have my foot off of the throttle it's at -14.69 psi and depending on how far I push the throttle it goes up/down.
Does this mean that my map sensor doesn't work? I assume that it should read atmospheric pressure when the engine is off correct?
I'm having troubles starting my car (my base timing won't sync properly, it keeps "walking") so I can't tell you how it acts with the car on.
thx for any help
|
Did you find out what was wrong? I found that on v1.19 you have to goto Setup -> Sensors-> MAP->options and set "Map Analog Input" to MAP Voltage instead of MAP as Load. Let me know if this helps.