3000GT/Stealth International Message Center - View Single Post - Pulled Pan

HugeJay · 02-24-2008, 09:16 AM

oh btw, dont think changing the rod bearing after its been spun will work right, chances are like the other poster stad the connecting rod needs to be replaced, I tried just to change the bearings it worked, but I still had a slight knock, to do it right you have to get it rebuilt. take our advice once you spin a bearing, its time to rebuild.

02-24-2008, 09:16 AM	#6 (permalink)
HugeJay Forum Member Join Date: Nov 2000 Location: Niagara Falls, ON Drives: 92 R/T Trader Rating: (2)	Re: Pulled Pan - Spun Bearing! oh btw, dont think changing the rod bearing after its been spun will work right, chances are like the other poster stad the connecting rod needs to be replaced, I tried just to change the bearings it worked, but I still had a slight knock, to do it right you have to get it rebuilt. take our advice once you spin a bearing, its time to rebuild. Last edited by HugeJay : 02-24-2008 at 09:52 AM.