3000GT/Stealth International Message Center - View Single Post - Pulled Pan

stephenson · 02-23-2008, 01:18 PM

That's kinda what I was thinkin, too ...

What if I just replaced all the rod bearings? If the one rod bearing is the only one that was affected - and, assuming I can get close to an in spec measurement on the remainder - is there a chance I could get a few thousand miles out of the engine?

Not main car, just a project ... :-)

02-23-2008, 01:18 PM	#3 (permalink)
stephenson Forum Member Join Date: Feb 2008 Trader Rating: (0)	Re: Pulled Pan - Spun Bearing! That's kinda what I was thinkin, too ... What if I just replaced all the rod bearings? If the one rod bearing is the only one that was affected - and, assuming I can get close to an in spec measurement on the remainder - is there a chance I could get a few thousand miles out of the engine? Not main car, just a project ... :-)