Re: MAFT Gen 2 - Anyone?
It sounds like the unit needs to be reset. The unit can get out of sync if you shut it off or unplug it less than 5 seconds after changing a setting.
Do this: Hold the upper right button while turning the unit on. You need to keep it held for 15 seconds or so until the unit says "all data reset".
Then reconfigure it, you should be fine from there on.
What # is the CEL?
Bob
__________________
Need a datalogger? Check out the Scanmaster 3
PM me about ECU mods for 8000+ RPM rev limits !!!!!!!!
Stock = 7300 RPM
Stage 1 = 8060 RPM
Stage 2 = 8200 RPM
Stage 3 = 8400 RPM
Stage 4 = 8800 RPM (By request only)
1991 Stealth RT/TT, Grooms Shortblock, 13G's, Translator Pro, www.maftpro.com
|