Quote:
Originally Posted by TurboBob
The LC1 has 2 analog outputs. You should program the other analog output as a regular LC1 and use it for the Gen-2.
I don't know where Clint got the 8.0 - 22.0 range from. He indicated that it was some sort of standard. But I have not found a single wideband unit that uses this range. If you know of one, let me know.
Bob
|
Bob,
After looking at Innovate's site, and comparing to my experience hooking up the LC-1, I remembered that "Output #1" on the LC-1 is actually pre-programmed to simulate a NB sensor in the .1V-1.1V range, and cannot be used with a WB.....just thought Id pass that along.....also, the factory "out of the box" output #2 (compatabile with realtime WB) is 0-5V = 7.35-22.30 AFR.......so it looks like Im out of luck on that one.....wonder why Clint didnt make the MMCD match the LC-1?
BUT, I would think the (2) values (MMCD & Gen2) would be closer, because the ranges are pretty close...but while MMCD was reading 13-14 AFR, GEN2 was reading 11.xx....much farther apart than I would expect....
Anyway, one more question:
Is it safe to assume that if "WB correction" is set at 100% that WB tracking is "disabled"?