3000GT/Stealth International Message Center - View Single Post - ---===The Official MAFT-Pro Thread===---

SuperchargedWS6 · 08-11-2007, 06:04 PM

OK, I got all my wiring done and thought that would be the hard part. I loaded v.489 onto the maft and went to put in the settings for AFC mode. Here's my settings along with questions:

Vehicle Select (2) - I am running timing control, is this correct?
#cylinders (6) - self explanitory
Displacement (3.00) - self explanitory
Airfl Mode (10) - got this from previous post, but maftpro says 10 is translator mode, and there is no AFC mode. What should this be???
Map Source (0) - GM 3 bar - I'm running the stock Baro, don't know what to set this to??
Load Source (0) - Use MAP is this correct?
Baro Mode (0) - Sealevel - is this correct?
F-Out (0) - I thought 0 puts the maftpro into AFC mode, but zero states "fuel pump control"???
Vout1 (0) - use setpoint
Vout2 (0) - use setpoint
AFR source (3) - AEM - I've got an AEM wideband
F-In mode (33) - got this from previous post. Is this correct?
Aux1 mode (0) - Aux trigger off
FlowErrMode (0) SD/MAF - this is undocumented- is this the correct mode?

08-11-2007, 06:04 PM	#2328 (permalink)
SuperchargedWS6 Forum Member Join Date: Nov 2005 Trader Rating: (1)	Re: ---===The Official MAFT-Pro Thread===--- OK, I got all my wiring done and thought that would be the hard part. I loaded v.489 onto the maft and went to put in the settings for AFC mode. Here's my settings along with questions: Vehicle Select (2) - I am running timing control, is this correct? #cylinders (6) - self explanitory Displacement (3.00) - self explanitory Airfl Mode (10) - got this from previous post, but maftpro says 10 is translator mode, and there is no AFC mode. What should this be??? Map Source (0) - GM 3 bar - I'm running the stock Baro, don't know what to set this to?? Load Source (0) - Use MAP is this correct? Baro Mode (0) - Sealevel - is this correct? F-Out (0) - I thought 0 puts the maftpro into AFC mode, but zero states "fuel pump control"??? Vout1 (0) - use setpoint Vout2 (0) - use setpoint AFR source (3) - AEM - I've got an AEM wideband F-In mode (33) - got this from previous post. Is this correct? Aux1 mode (0) - Aux trigger off FlowErrMode (0) SD/MAF - this is undocumented- is this the correct mode? __________________ ------------------------------- Brent M. 1995 3000GT Twin Turbo - It's running! Mod list soon! 1998 Dakota V8 4x4, 4 the winter Wife's car - Lost the wife due to all the time/money spent on the VR4! At least she didn't get the car! Mitsubishi - My Life's Work!