3000GT/Stealth International Message Center - View Single Post - Front subframe design - suspension/steering experts please provide input

ah4449 · 06-06-2007, 11:23 PM

Look into allowing a little more room between the oil filter housing and the subframe, basically where the oil cooler fittings thread on. Main reason for bringing this up is I just put on an aftermarket SMOC and used AN fittings and had to buy another set of 90 degree adaptors other than the ones I already had because there wasn't enough room... The fittings still didn't hang down past the oil pan or anything they looked perfect until I tried to put the subframe piece back on, which was where the problem was...

And I would definitely be interested in a modified/redone subframe, I hate those stock pieces; pending price and all that normal stuff.

My .02...

06-06-2007, 11:23 PM	#2 (permalink)
ah4449 I need $$$$$ Join Date: May 2005 Location: Livermore, CA Drives: 92 tt lemon Trader Rating: (7)	Re: Front subframe design - suspension/steering experts please provide input Look into allowing a little more room between the oil filter housing and the subframe, basically where the oil cooler fittings thread on. Main reason for bringing this up is I just put on an aftermarket SMOC and used AN fittings and had to buy another set of 90 degree adaptors other than the ones I already had because there wasn't enough room... The fittings still didn't hang down past the oil pan or anything they looked perfect until I tried to put the subframe piece back on, which was where the problem was... And I would definitely be interested in a modified/redone subframe, I hate those stock pieces; pending price and all that normal stuff. My .02... __________________ Someday it might run... But for now, it sits