Iv been reading up on this thread for the past two days. So if this is covered somewhere in here i am sorry:has anyone had any issues with running the hot wire kit and a kenne-bell bap? just installed the AEM and havent even wired up the sensors yet, but was curious if there were any issues. Also looking for a start up cal. penguins--sorry didnt know you werent doin them anymore for free(email I sent a few days ago)hoping to find someone with similiar set up.
dr-800
720cc densos
fmic
kenne bell and hot wire(also relay jumpered)
aem 3.5bar
aem iat
ported heads
stock cams with adj cam gears +1, -3
aftermarket coils(cnc motorsports-yellow ones)
hks twin dli
3.1 motor
aem gauge wideband single
........????
I found an old one in this thread but it was the 1.11v--can you upconvert without losing info?
any help is appreciated.
Matt
n2ostealth@gmail.com