Re: ---===The Official MAFT-Pro Thread===---
try unplugging the 6 pin harness when you update. Try unplugging whetever else is convenient. The communications use the same internal voltage sources as the analog section, and if its overloaded (install issue...) it will mess with the communication.
The current pro's don't need the buttons held when updating.
I use the update procedure to program them when they are built, so it will work. We just need to find out whats up.
Bob
__________________
Need a datalogger? Check out the Scanmaster 3
PM me about ECU mods for 8000+ RPM rev limits !!!!!!!!
Stock = 7300 RPM
Stage 1 = 8060 RPM
Stage 2 = 8200 RPM
Stage 3 = 8400 RPM
Stage 4 = 8800 RPM (By request only)
1991 Stealth RT/TT, Grooms Shortblock, 13G's. <-- Gone but not forgotten
|