3000GT/Stealth International Message Center - View Single Post - ---===The Official MAFT-Pro Thread===---

TurboBob · 08-25-2006, 06:01 PM

here is the posting:

Update files

from 4.65 there is a change to the number of cylinders you can have (special for a customer) and this change.

To make timing monitor run, you need to connect the yellow MAFT Pro wire to the ECU TACH wire. Clip R7 resistor, and set F IN mode to 22

Then tune it to match your logger or timing light.

Bob

08-25-2006, 06:01 PM	#1427 (permalink)
TurboBob Resident mad scientist Join Date: Jan 2003 Location: Near Detroit Drives: 86 GN 91 RT/TT Trader Rating: (17)	Re: ---===The Official MAFT-Pro Thread===--- here is the posting: Update files from 4.65 there is a change to the number of cylinders you can have (special for a customer) and this change. To make timing monitor run, you need to connect the yellow MAFT Pro wire to the ECU TACH wire. Clip R7 resistor, and set F IN mode to 22 Then tune it to match your logger or timing light. Bob __________________ Need a datalogger? Check out the Scanmaster 3 PM me about ECU mods for 8000+ RPM rev limits !!!!!!!! Stock = 7300 RPM Stage 1 = 8060 RPM Stage 2 = 8200 RPM Stage 3 = 8400 RPM Stage 4 = 8800 RPM (By request only) 1991 Stealth RT/TT, Grooms Shortblock, 13G's. <-- Gone but not forgotten